Omron fh series Hardware Manual page 219

No. Signal name
B13 BUSY0
B14 GATE0
B15 OR0
B16 READY0
B17 DO0
B18 DO2
B19 DO4
B20 DO6
B21 DO8
B22 DO10
B23 DO12
B24 DO14
B25 DO15
• Handling the output common terminals
COMOUT1: STGOUT0 to 3, RUN/BUSY1, ERROR, BUSY0, OR0 to 1, GATE0 to 1
COMOUT2: READY0 to 1, DO0 to 7
COMOUT3: DO8 to 15
*1. This is a signal that is used when the strobe device is connected to the Controller.
*2. This signal is only available in the Random trigger mode.
*3. ON while the layout turned on output setting is displayed/ON during processing
Internal Specifications for Parallel Interface
[Input]
Applicable signals:
RESET, DI0 to DI7, DSA0, DSA1
Item
Internal circuit diagram
[Input]
Applicable signals:
STEP0/ENCTRIG_Z0, STEP1/ENCTRIG_Z1, ENCTRIG_A0 to 1, ENCTRIG_B0 to 1
Item
Internal circuit diagram
Vision System FH/FZ5 series Hardware Setup Manual (Z366)
Wire color Mark (red)
White
Yellow
Pink
Orange
Gray
White
Yellow
Pink
Orange
Gray
White
Yellow
Pink
Each input terminal
+
Each input terminal
+
6 I/O Interface
Function
ON during processing
ON for the set output time
Overall judgment result
ON when image input is allowed
Data output
Specifications
COM IN
Specifications
COM IN
6
6 - 27