Insert Sd Memory Card Or Usb Memory - Omron fh series Hardware Manual

5 Setup and Wiring
5-6 Insert SD Memory Card or USB mem-
ory
Precautions for Correct Use
When removing USB memory
• Confirm the SD memory card of USB memory is not in running, and then remove it.
• Before removing a USB memory device or SD memory card, make sure that data is not being
read or written to them.
• When a message is displayed indicating that a task is in progress, do not turn OFF the
power.
• Do not insert or remove USB memory during measurement, loading, and writing.
There is the possibility of measurement time or damage of data.
• When you connect the USB memory using USB hub, the drive name after launching can be changed.
If you want to ensure the drive name does not change, connect to the USB port directly without using
USB hub.
5-6-1 FH-1000/FH-3000 Series
Precautions for Correct Use
Handling of SD memory card
• When you touch a terminal part of SD memory card, antistatic is required by using a wrist
strap or others.
• Do not insert an SD memory card in the reverse orientation, at an angle, or in a twisting man-
ner.
Removing SD memory card
• Before removing a SD memory card, make sure that data is not being read or written to them.
• For an SD memory card, the SD BUSY LED of Sensor Controller flashes while data is being
read or written.
Make sure that the LED stops flashing before removing the card.
• When a message is displayed indicating that a task is in progress, do not turn OFF the
power.
Do not insert or remove SD memory card during measurement, loading, and writing.
There is the possibility of measurement time or damage of data.
Additional Information
For external memory device, refer to the Using External Memory Devices in Vision System
FH/FZ5 Series User's Manual (Cat. No. Z365).
5 - 32 Vision System FH/FZ5 series Hardware Setup Manual (Z366)