Changing Transmission Fluid - Kubota RTV1140 CPX Operator's Manual

BChanging Transmission Fluid
To avoid personal injury:
A Be sure to stop the engine before changing the
oil.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Park the vehicle on a flat surface, raise the cargo bed,
mount the safety support.
2. To drain the used oil, remove the drain plug at the
bottom of the transmission case and drain the oil
completely into the oil pan.
3. After draining, reinstall the drain plug.
4. Fill with the new KUBOTA SUPER UDT fluid up to the
upper notch on the dipstick.
(See "LUBRICANTS, FUEL AND COOLANT" in
"MAINTENANCE" section.)
5. After running the engine for a few minutes, stop the
engine and check the oil level again; add oil to
prescribed level.
Oil Capacity
(1) Oil inlet (A) Oil level is acceptable within this range
(2) Gauge
12 L (3.2 U.S.gals.)
(1) Drain plug
A Do not operate the vehicle immediately after changing
the transmission fluid.
Run the engine at medium speed for a few minutes to
prevent damage to the transmission.
PERIODIC SERVICE 69