Ice Maker Testing Procedures; Operating Cycle; Operating Cycle Illusttations - Manual Cycle; Operating Cycle Illusttations - Electrical - Electrolux E23CS75DSS0 Service Manual

Ice Maker Testing Procedures

Operating Cycle

Operation of the ice Maker, water refilling, and
controlled ice storage, require proper functioning
and timing of all components.
Consider the following:
• Has refrigerator been properly installed and
connected to sources of electrical power and
water?
• Has freezer compartment evaporator pulled
down to temperature?
• Is the ice maker turned on?
• Have several ice making cycles been
completed to remove all the air form the
water lines?
•Do the ejector blades make two revolutions per
cycle? Is ice stored on blades after harvest?
• Is the water solenoid wired in series with the
mold heater?
Operating Cycle Illustrations - Electrical
The following wiring diagrams illustrate the electrical operation of a rear mount ice maker.
1
Section F - Ice Maker
Operating Cycle Illustrations - Manual
Cycle
To manually cycle ice maker:
1. Turn the On Off switch to ON
2. Press in on switch holding the spring loaded
contact set closed, this will allow the motor to
start.
3. Hold in on the switch for 10 seconds to allow
hold switch contacts to close allowing the ice
maker to continue through a cycle.
• Ice Maker connected to electricity.
• Mold temperature above 9°F.
• Thermostat open.
• Motor not rotating.
• Mold Heater off.
• Control Arm in the down position.
• Feeler Arm Switch closed C to NO.
• Hold Switch closed C to NC.
• Water Fill Switch open.
91