Overtorque Detection Function - ACP Speecon 7200M3 Manual

This function is used when operation at an arbitrary speed must be indicated. By setting either set value to
multifunction contact output function ( Pn-34 , Pn-35 ) the following signal output to control circuit
terminal 13 or 14 is enabled. Set 1 or 3 to Pn-34 or Pn-35 when the signal is to be output to control circuit
terminals 13 and 14 , respectively.
(1) Set value = 1 : frequency agreed
DETECTION WIDTH ±
OUTPUT FREQUENCY
AGREED FREQUENCY
SIGNAL
(2) Set value = 3 : output frequency ≧ frequency detection level
However, When "frequency agreed" is selected, the frequency agreed signal is turned OFF immediately at
stop signal input.
DETECTION WIDTH
OUTPUT FREQUENCY
RUN SIGNAL
FREQUENCY AGREED
SIGNAL

2.7.18 OVERTORQUE DETECTION FUNCTION

Item Name
Overtorque Detection Level
2Hz
OUTPUT FREQUENCY
FREQUENCY
DETECTION SIGNAL
2Hz
±
Constant to be set
- -
CLOSED
CLOSED
CLOSED
Factory Preset
38
92
FREQUENCY REF.
Pn-36
160%