Ultifunction Contact Input Function Selection - ACP Speecon 7200M3 Manual

2.7.15 ULTIFUNCTION CONTACT INPUT FUNCTION SELECTION

Item Name
Multifunction Contact Input Function
The function of control circuit terminals 4 and 5 can be changed if necessary.
Set Pn-32 and Pn-33 in the descending order.
Pn-32 set value ＜ Pn-33 set value
Terminal 4 function: Set to Pn-32
Set Value Function
0(Note) FWD/REV run command (3-wire sequence selection)
1 External fault (NO contact input
2 External fault (NC contact input)
Constant to be set
32 , 33
- - 88
Factory PRESET
Refer to page 63
Page
ˍ
101
101