Inverter Status Display Led - ACP Speecon 7200M3 Manual

˙ Turn the frequency setter knob slowly to the left to decrease
˙ Depress RUN key.
value fully.
Stopping
• Turn off FWD or REV run signal.
Note: 1. Models with analog operator (the standard setting preset at the factory prior to shipping) need not
this operation.
2.Refer. to Par.2.2 "DIGITAL OPERATOR OPERATION EXAMPLE"
(Page 49) for details of digital operator operation.

1.5.4 Inverter Status Display LED

With the model with analog operator or free kit operator, LED provided for the inverter is of help to know
the inverter status. This LED can be seen by removing the terminal cover or from the right side without
removing the cover. Inverter status can be seen by the LED lighting modes. Table 1.6 shows the LED
lighting modes and the contents. Check that the inverter is in the normal status at power ON in the test run
stage. Free kit operator (JNEP--15) has are LED on the operator cover also, it display the same inverter
status as showing in table 1.6.
Table 1.6 LED Display and Contents
- - 25