Control Circuit - ACP Speecon 7200M3 Manual

1.4.4 Control Circuit

(1)Control circuit wiring
Fig.1.6 shows the relation between the I/O signals (factory pre-set values) and screw terminal numbers.
The control signals are connected by screws. The terminal functions shown in the figure indicate standard
setting prior to shipping. Since operation mode from the digital operator is set for the model with the
digital operator, it is necessary to change the control constants when operation is performed from the
control circuit terminals.
For the model with analog operator (JNEP--14) operation mode from the control circuit terminals is the
standard setting preset at the factory prior to shipping.
BRAKING RESISTOR UNIT (OPTION)
B1/P
(R)
(S)
(T)
1
2
3
MULT1-FUNCION
4
CONTACT INPUT
8
9
- - 17
B
A
B
C
13
14
COMPENSATION RESISTOR FOR
CONNECT IF NECESSARY