Function/Constant Setting; Drv (Drive) Mode And Prg (Program) Mode - ACP Speecon 7200M3 Manual

Lamp
: Light

2.1 FUNCTION/CONSTANT SETTING

2.1.1 DRV (Drive) Mode and PRG (Program) Mode

Selection of DRV mode or PRG mode can be performed by using the
When function selection or a change of set value is required, switch to the PRG mode.
DRV mode: • Operation is enabled.
• An operation can be performed by
keys.
• Frequency reference value can be changed during running.
PRG mode: • Program (function selection, constant setting) can be changed.
• Operation is not enabled.
Display Contents of DRV Mode and PRG Mode
(1) Display contents of the digital operator differ according to selected mode (PRG/DRV).
(2) The constant group to be displayed is changed each time display selection key DSPL is depressed.
(3) If a fault occurs, the contents are displayed. Additionally, since the contents of the latest fault are
stored, maintenance, inspection or troubleshooting can be performed quickly by checking the
contents by digital operator.
●
: Blink : Off
, or
,
RUN
- - 48
key when the inverter is stopped.
FWD
STOP JOG
REV