Run/Stop Procedure Selection - ACP Speecon 7200M3 Manual

2.7.2 RUN˙ STOP PROCEDURE SELECTION
Item Name
Start/Stop Procedure
Reverse Rotation Prevention
*The value in parentheses is factory setting of models with analog operator (JNEP- -14)
Start procedure
Operation can be performed from the operator or control circuit terminal input.
1 = X X 0 0 (X means 1 or 0 )
1st digit
0: Frequency reference from control circuit terminal
2nd digit
0: Start/stop control from control circuit terminal
Stop procedure
Stopping mode can be selected according to the application.
1 = X 0 X X
3rd digit
0:Deceleration to stop
Reverse rotation
Constant to be set
1
20
1: Frequency reference from the operator.
1: Start/stop control from the operator.
1:Coasting to stop.
- -
Factory Preset
0011(0000)*
0000
72