Specifications - ACP Speecon 7200M3 Manual

1.8 SPECIFICATIONS

1.8.1 Specifications
Voltage Class
Inverter Model
Max. Applicable Motor
Output HP (KW) *1
Inverter Capacity KVA
Rated Output current A
Max. Output Voltage V
Max. Output Frequency
Rated Input Voltage and Freq.
Allowable Volt. Fluctuation
Allowable Freq. Fluctuation
Control Method
Freq. Control Range
Frequency Accuracy
Freq. Setting Resolution
Output freq. Resolution
Overload Capacity
Freq. Setting Signal
Accel/Decel. Time
Braking Torque
V/F Characteristic
Stall prevention level
Instantaneous OC
Overload
Motor overload
Overvoltage
Undervoltage
Momentary Power loss
Cooling Fin Overheat
Power Charge Indication
*1. TECO standard 4-pole motor is used for max. applicable motor output
*2. To select "automatic restart after momentary power loss " set the 1
R500 0001
0.5(0.4) 1(0.75) 2(1.5)
1.4 2.1
3.2 4.8
3-phase 200 to 230V , 50/60 Hz (proportional to input voltage)
400 Hz (available with constant setting)
3-phase 200 to 230V , 50/60 Hz
Digital command: 0.01%, Analog command : 0.1%
Digital : 0.1 Hz , Analog : 0.06/60Hz
150% rated output current for one minute
0 to 10v (20kΩ), 4 to 20 mA (250Ω)
0.1 to 600 sec (accel/decel time setting independently)
Approx. 20%(up to 150% possible with optional braking resistor)
Possible to set any program of v/f pattern
Possible to set operating current
Motor coasts to stop at approx. 200% rated current
Motor coasts to stop for 1 minute at approx. 150% rated output current
Electronic thermal overload relay
Motor coasts to stop if main circuit voltage exceeds 410v
Stop when main circuit DC voltage is approx. 210v or less
Protected by thermoswitch (only for forced cooling method)
Charge lamp stays on until main circuit DC voltage drops below 50v
- -
220 3-phase
JNTABDCB JK---
0002 0003 0005
3(2.2) 5(3.7) 7.5(5.5) 10(7.5)
2.7 4.1 6.9
6.5 9.6 16
± 10 ％
± 5 ％
Sine wave PWM
0.1 to 400 Hz
0.1 Hz
15ms or longer *2
37
7R50 0010
10.3 13.7
24 32
st
digit of constant (Pn-46) to "1"