Routine Maintenance - Parker 590 series Product Manual

R
OUTINE
1 0

Routine Maintenance

Repair
IMPORTANT: MAKE NO ATTEMPT TO REPAIR THE UNIT - RETURN IT TO PARKER SSD DRIVES.
Saving Your Application Data
Returning the Unit to Parker SSD Drives
Disposal
590 Series DC Digital Converter
M
AINTENANCE AND
Maintenance and repair should only be performed by competent persons using only the
recommended spares. Use of incorrect parts may create a hazard and risk of injury.
Periodically inspect the Converter for build-up of dust or obstructions that may affect ventilation
of the unit. Remove this using dry air.
There are no user-serviceable components.
The Converter retains saved settings during power-down. You can download and upload this
back into the repaired unit, if necessary. You may, depending upon your knowledge of the fault,
attempt the back-up of your application data now, refer to Chapter 5: "The Man-Machine
Interface (MMI)" - Copying an Application.
If the fault clearly lies within the MMI, then return the unit for repair.
Please have the following information available:
•
The model and serial number - see the unit's rating label
•
Details of the fault
•
Complete the "Technical Support Checks" detailed over the page (if electrically competent)
Contact your nearest Parker SSD Drives Service Centre to arrange return of the item.
You will be given a Returned Material Authorisation. Use this as a reference on all paperwork
you return with the faulty item. Pack and despatch the item in the original packing materials; or
at least an antistatic enclosure. Do not allow packaging chips to enter the unit.
This product contains materials which are consignable waste under the Special Waste
Regulations 1996 which complies with the EC Hazardous Waste Directive - Directive
91/689/EEC.
We recommend you dispose of the appropriate materials in accordance with the valid
environmental control laws. The following table shows which materials can be recycled and
which have to be disposed of in a special way.{xe "Disposal" \f }
Material
metal
plastics material
printed circuit board
The printed circuit board should be disposed of in one of two ways:
1. High temperature incineration (minimum temperature 1200°C) by an incinerator authorised
under parts A or B of the Environmental Protection Act
2. Disposal in an engineered land fill site that is licensed to take aluminium electrolytic
capacitors. Do not dispose of in a land fill site set aside for domestic waste.
Packaging
During transport our products are protected by suitable packaging. This is entirely
environmentally compatible and should be taken for central disposal as secondary raw material.
Routine Maintenance and Repair
R
EPAIR
Caution
Recycle
yes
yes
no
8-1
Disposal
no
no
yes