How To Save, Restore And Copy Your Settings; Saving Your Application; Restoring Saved Settings; Copying An Application - Parker 590 series Product Manual

How to Save, Restore and Copy your Settings

Saving Your Application

Note: Ensure that CONFIGURE ENABLE = DISABLED before performing

Restoring Saved Settings

Copying an Application

590 Series DC Digital Converter
a PARAMETER SAVE (when set to ENABLED, the drive cannot run).
The PARAMETER SAVE menu, available in the both the full and
reduced view levels, is used to save any changes you make to the MMI
settings.
Pressing the ↑ (UP) key, as instructed, saves all parameter
values in non-volatile memory, i.e. values are stored
during power-down.
If you are unsure about any changes you have made and you have not yet performed a
PARAMETER SAVE, simply switch the Converter off, and power-up again. The "last saved"
parameter settings will be restored.
Copying an application requires a host computer connection to the Converter's P3 port.
Information can then be downloaded to the computer (and uploaded to the Converter).
Refer to Chapter 14: "Serial Communications" for further information.
The Man-Machine Interface (MMI)
5-7
MMI Menu Map
1
SYSTEM
2
CONFIGURE I/O
CONFIGURE ENABLE
PARAMETER SAVE
1
1
UP TO ACTION