Startup - Sartorius U 3600, Installation And Operating Insctructions

Startup.

Install the pan on your toploader.
The operating voltage was set to 220 V at the factory.
Adaptation to your local line voltage:
set the voltage selector (2) to your line voltage.
Write the new setting on the manufacturer's label (3). Whenever
you change the voltage to 100/120 you must switch fuses: ex-
change the T 160 mA fuse (2) for the T 315 mA fuse that is in-
cluded in the toploader.
You will find this fuse plugged in the rear panel together with the
voltage selector:
100/120 V-T 315mA
220/240 V-T160mA
At the point of use, plug the line cord into a properly installed
line outlet.
lf you have to use a line outlet that lacks the ground wire,
make sure you ground the toploader itself.
6