3.1.10. Extend Port Config
Select "Basic Config" and "Port Config" and then "Extend Port Config" to open the
screen shown in Figure 3-10. On this screen, you can configure port status display
settings and mode and other settings.
Screen Description
Global Jumbo Sta-
tus
Port Number
Type
Link Status
Port Name
Figure 3-10 Extend Port Config
Displays the jumbo frame settings.
Enable
Disable
Displays the port number.
Displays the port type.
1000T
1000X
Displays the current link status.
Up
Down
Displays the port name.
The jumbo frame is enabled.
The jumbo frame is disabled.
(Factory default setting)
The port type is 1000BASE-T.
The port type is SFP expansion port.
A link has been established successfully.
A link has not been established.
30