Dmi (Ddm) Config - Panasonic PN28080K-ID Operation Manual

3.2.18. DMI (DDM) Config

Select "Advanced Config" and "DMI (DDM) Config" to open the screen shown in
Figure 3-44. On this screen, you can configure the DMI (Digital Diagnostic Monitor-
ing Interface) settings.
Screen Description
Limit Trap
Target SFP Port
Number
Vendor Name
Port Product Num-
ber
Port Serial Number
Transceiver Type
RX Power(dBm)
TX Power(dBm)
Temp(deg.C)
Voltage(V)
Bias Current(mA)
Figure 3-44 DMI (DDM) Config
Displays the status of the Limit Trap function.
Enable Enables Limit Trap.
Disable Disables Limit Trap.
Displays the SFP port number to be displayed and configured.
Displays the vendor name.
Displays the product number.
Displays the serial number.
Displays the Transceiver Type.
Displays the current, maximum, and minimum values of RX Power(dBm). The
maximum and minimum values can be configured.
Displays the current, maximum, and minimum values of TX Power(dBm). The
maximum and minimum values can be configured.
Displays the current, maximum, and minimum values of Temp(deg.C). The
maximum and minimum values can be configured.
Displays the current, maximum, and minimum values of Voltage(V). The maxi-
mum and minimum values can be configured.
Displays the current, maximum, and minimum values of Bias Current(mA). The
maximum and minimum values can be configured.
72