Panasonic PN28080K-ID Operation Manual page 17

Screen Description
System Informa- Displays the operating time and firmware version of this switch.
tion
Operating Time
Boot Code
Version
Runtime Code
Version
Hardware Displays the hardware information.
Hardware Version
DRAM Size
Flash Size
Console Baud Rate
System Fan Status
System Temperature
Management Configure the items shown here in accordance with "Administration Configra-
tion" in Section 3.1.1.
Host Name
Location
Contact
System Address Configure the items shown here in accordance with "IP Config" in Section
3.1.2.
MAC Address
IP Address
Subnet Mask
Default
Gateway
★ IPv6 アクセス
★ IPv6 アドレス／
プレフィックス長
★ IPv6 リンク
★ローカルアドレ
ス
★ IPv6 デフォルト
ゲートウェイ
Displays the cumulative time since the power on of this
switch.
Displays this switch's firmware version.
* The firmware update described in Section 3.3.1 is available
only for runtime codes.
Displays the hardware version.
Displays the size of the installed DRAM.
Displays the size of the installed Flash memory.
Displays the baud rate of the console.
Displays the operation status of the installed fan.
Displays "Good" when the fan is operating normally
and "Fail" when it fails or stops.
Displays the internal temperate of the switch.
The temperature sensors measure the temperatures
of the CPU and system.
Displays the switch name. The factory default setting is
blank. For configuration details, refer to Section 3.1.1.
Displays the switch's location. The factory default setting is
blank. For configuration details, refer to Section 3.1.1.
Displays the contact information. The factory default setting
is blank. For configuration details, refer to Section 3.1.1.
Displays the MAC address of this switch. This value is
uniquely assigned to each device and cannot be changed.
Displays the switch's current IP address. "0.0.0.0" is the fac-
tory default setting. For configuration details, refer to Sec-
tion 3.1.2.
Displays the switch's current subnet mask. "0.0.0.0" is the
factory default setting. For configuration details, refer to
Section 3.1.2.
Displays the IP address of the router for the default gate-
way. "0.0.0.0" is the factory default setting. For configura-
tion details, refer to Section 3.1.2.
Displays whether the IPv6 address is enabled or disabled.
Displays the current IPv6 address and prefix length of this
switch. "::/128" is the factory default setting. For configura-
tion details, refer to Section 3.1.2.
Displays the current IPv6 link local address of this switch. "::"
is the factory default setting. For configuration details, refer
to Section 3.1.2.
Displays the IPv6 address of the router for the default gate-
way. "::" is the factory default setting. For configuration
details, refer to Section 3.1.2.
17