Egress Rate Limiting Config - Panasonic PN28080K-ID Operation Manual

3.2.5.

Egress Rate Limiting Config

Select "Advanced Config" and "QoS Config" and then "Egress Rate Limiting Config"
to open the screen shown in Figure 3-29. On this screen, you can configure the
Egress Rate settings.
Screen Description
Target Port Selecting
Port Number
Bandwidth
Status
Figure 3-29 Egress Rate Limiting Config
Select multiple target ports for configuring settings at a time.
Click the "Select All" button, and all ports will be selected.
Click the "Reset" button, and all ports will be deselected.
Click the "Set selected port (s) " button after selecting and changing the
items for configuring settings at a time, and the same settings will apply
to the selected ports.
Displays the port number.
Displays the bandwidth. The factory default setting is 1000. (The unit is
Mbps)
Displays whether the bandwidth control settings are enabled or disabled.
Enable The bandwidth control settings are enabled.
Disable The bandwidth control settings are disabled.
52