Press 4 for 'Shut Down' option and Synectix VMS Lite prompts with:
Press 1 to Confirm Shut Down.
Press 9 for Cancel & Return to Previous Menu.
If you confirm the shutdown procedure, the Synectix VMS Lite terminates all its tasks
one by one, busies out all its ports so that no calls are forwarded to it by the PBX and
then goes into an idle mode. The unit may be safely powered off at this point. The unit
must be powered off and then on again to put it back into normal operation.
1.5
System Parameters
It is very important that the System parameters be programmed correctly for the
Synectix VMS Lite to function properly. These parameters are protected by a password
to ensure that only the installer has the permission to access these parameters.
The Synectix VMS Lite should be configured to work correctly with the PBX to which it
is connected, as a lot of parameters are very PBX-specific. Some global parameters
(Usage Parameters) are also set through 'System Parameters'.
After you press 5 for 'System Parameters', the Synectix VMS Lite prompts you with the
following choices:
Press 1 for PBX Parameters. (1.5.1)
Press 2 for Usage Parameters. (1.5.2)
Press 6 to Listen to Serial Number. (1.5.3)
1.5.1
PBX Parameters
Some system parameters require a special programming method, as some special
characters are required to be entered.
For example, while programming the 'Enable String', 'Disable String' for Message
Waiting Lamp, In-band Strings, Transfer & Retrieve Strings, you have to enter a Pause or
a Hook-flash etc. as part of the desired string to be used by the Synectix VMS Lite.
For all such special entries, the following two-digit combination must be used while
programming :
**
*0
*1
*2
*3
*4
*5
*6
*7
*8
=
*
=
Hook-flash
=
Pause
=
#
=
Extension place holder
=
Ignore character
=
A
=
B
=
C
=
D
Synectix VMS Lite
25
Need help?
Do you have a question about the VMS Lite and is the answer not in the manual?