Dell SMA 200 Administration Manual page 245

To have the user inherit the NetExtender settings from the group it belongs to (or from the global NetExtender
settings if the user does not belong to a group), select Use Group Settings for any of the previous options.
Configuring User NetExtender Routes
To configure user NetExtender routes:
1 To add a NetExtender client route that is only added to this user, click the Nx Routes tab in the Edit
User Settings window.
2 Click Add Client Route.
3 Type the IPv4 or IPv6 address of the trusted network to which you would like to provide access with
NetExtender in the Destination Network field.
4 For an IPv4 client route, type the subnet mask in the Subnet Mask/Prefix field. For an IPv6 client route,
type the prefix in this field.
5 Click Add.
6 Repeat steps 1 through 5 for all necessary routes.
7 Select Enabled from the Tunnel All Mode drop-down list to force all traffic for this user—including
traffic destined to the remote users' local network—over the Secure Mobile Access NetExtender tunnel.
8 To also add the global NetExtender client routes (which are configured on NetExtender > Client Routes
page) to the user, select Add Global NetExtender Client Routes.
9 To also add the group NetExtender client routes for the group the user belongs to, select Add Group
NetExtender Client Routes. Group NetExtender routes are configured on the NetExtender tab of the
Edit Group window that is accessed through the Users > Local Groups page.
10 Click Accept.
NOTE: When using an external authentication server, local user names are not typically configured on the
SMA/SRA appliance. In such cases, when a user is successfully authenticated, a local user account is
created with the Add Global NetExtender Client routes and Add Group NetExtender Client routes
settings enabled.
Dell SonicWALL Secure Mobile Access 8.5
Administration Guide
245