Checking and refilling
Read and observe
and
Check and refill coolant under the following conditions.
The vehicle is on a horizontal surface.
The engine is not warm (if the engine is warm the result of the check may
be wrong).
The engine is turned off.
Check the coolant level - The coolant level must lie between the marks
» Fig.
294. If the coolant level is below the mark
B
Refilling
The reservoir must always contain a small amount of coolant
›
Place a cloth over the cap of the coolant expansion reservoir and unscrew
the cap carefully.
›
Always top up using coolant of the correct specification.
›
Turn the cap until it clicks into place.
The specification for the coolant is shown in the coolant expansion reservoir
» Fig.
294.
If the specified coolant is not available, then refilling only with distilled or puri-
fied water, and get a specialist garage to correct the water-coolant additive
mix as soon as possible.
Fig. 294
Coolant expansion reservoir
on page 256 first.
, top up with coolant.
B
»
CAUTION
If the expansion tank is empty, do not top up with coolant. The system could
■
aerate - There is a risk of engine damage!
gine and seek assistance from a specialist garage.
Do not fill the coolant above the mark
■
heated, be expelled from the cooling system - There is a risk of damage to the
engine parts.
If it is not possible to add
■
seek assistance from a specialist garage.
A coolant additive which does not correspond to the correct specification can
■
reduce the anti-corrosion effect of the cooling system - risk of damage to the
cooling system and the engine.
If distilled (purified) water has been used to top up, the coolant should be re-
■
placed by a specialist garage - risk of engine damage.
A loss of coolant indicates leaks in the cooling system - risk of engine dam-
■
age. Top up with coolant and then seek assistance from a specialist garage.
Note
A coolant level which is too low is indicated in the instrument cluster by the
warning light and shown by the relevant message
and
A
mend inspecting the coolant level directly at the reservoir from time to time.
Brake fluid
.
Check the brake fluid under the following conditions.
The vehicle is on a horizontal surface.
The engine is turned off.
Check brake fluid level - The brake fluid level must lie between the markings
"MIN" and
"MAX"» Fig.
Stop driving! Switch off the en-
» Fig.
294. The coolant could, when
A
coolant,
stop driving! Switch off the engine and
» page
Fig. 295
Brake fluid reservoir
295.
Inspecting and replenishing
38. We still recom-
257