Skoda Octavia Owner's Manual page 288

Removing/installing tail light
Fig. 337 Remove light / pull out connector

Read and observe and
Removing
›
Open the boot lid.
›
Insert the clamps for removing the full wheel trims into opening
» Fig. 337.
›
Remove the cover by pulling the hook in the direction of arrow
›
Unscrew the screws with the key from the tool kit.
B
›
Hold the light and carefully remove in the direction of arrow
›
Press the latches on the connector
›
Carefully remove the connector from the tail lamp assembly in the direction
of the arrow .
4
Fitting
›
Insert the connector into the light and lock it securely.
1)
The position of the opening may vary depending on the vehicle model.
2)
The design of the plug can vary depending on the vehicle equipment.
286
Do-it-yourself
on page 282 first.
.
2
in the direction of arrow
2) 3
›
Insert the lamp with the pin
» Fig. 337 in the body.
›
Carefully push the cover in
›
Screw the tail lamp into place and install the cover. The cover must engage
securely.
›
Shut the boot lid.
CAUTION
Ensure that the cable bundle does not become stuck between the body and
■
the lamp when it is being refitted – or there is a risk of damage to the electrical
installation and risk of water ingress.
If you are not sure whether the cable bundle has become pinched, we recom-
■
mend that you have the light connection checked by a specialist garage.
Ensure that the vehicle paintwork and the tail lamp are not damaged when
■
removing and installing the tail lamp.
Replacing the bulbs in the tail lamp assembly - Variant 1
A
1)
Fig. 338 Outer part of the light: Basic light/light with LED diodes
.
1
.
» Fig. 338 on page 286 into the recesses
A
» .
C
