Skoda Octavia Owner's Manual page 47

Display Infotainment
›
Press the button, then tap on the function surface  → Driving data.

Screen display » Fig. 27
Distance travelled
A
Driving time
B
Average speed
C
Average fuel consumption
D
Transit point rating (DriveGreen Function)
E
Range (if the estimated range is less than 300 km, the vehicle starts to ap-
F
proach the symbol )
Approximate range
G
1)
Use the function surfaces   to select one of the following presets.
▶
Since start - Driving data for the individual trip
▶
Long-term - Long-term driving data
▶
Since refuel - Data since refuelling
Warning at when exceeding the set speed
The system offers the possibility to set a speed limit beyond which an acoustic
warning signal will sound and the following warning message appears in the
display of the instrument cluster.
Adjust the speed limit while the vehicle is stationary
›
Select the menu item Warning at at () or  () and confirm.
›
Set the desired speed limit is 5 km/h steps.
1)
For vehicles with CNG drive the approximate range with gasoline and CNG is displayed separately.
Fig. 27
Driving data
›
Confirm the set value, or wait several seconds; your settings will be saved
automatically.
Adjusting the speed limit while the vehicle is moving
›
Select the menu item Warning at at () or  () and confirm.
›
Drive at the desired speed.
›
Confirm the current speed as the speed limit.
The set speed limit can be manually adjusted later if needed.
Reset speed limit
›
Select the menu item Warning at at () or  () and confirm.
›
By confirming the speed stored in the memory, the speed limit is reset.
The speed limit set mode is stored even after the ignition is switched off and
on. After a gap between driving exceeding 2 hours, the pre-set speed limit is
deactivated.
Memory
The system saves the data in the three memories described below which are
displayed at the position » Fig.
A
Since start (  ) Or "1" (  )
Driving data is stored from when the ignition is switched on to when it is
switched off. If the trip is continued within 2 hours after switching off the igni-
tion, new data will also flow into the calculation of the current driving informa-
tion.
If the trip is interrupted for more than 2 hours, the memory is automatically
erased.
Fig. 28
Memory display: MAXI DOT dis-
play ()/segment display ()
28.
Information system

45