Skoda Octavia Owner's Manual page 52

›
Then follow the instructions in the manual, which is included in the
SmartGate application.
The password for the connection to SmartGate _...
of the vehicle identification number
With SmartGate, a maximum of two external devices can be connected simul-
taneously using Wi-Fi direct, with as many launched ŠKODA applications as re-
quired.
If you want to connect to SmartGate in a different vehicle, you must make a
new connection in the SmartGate application.
Disconnection
The connection can be switched off in one of the following ways.
›
Switch off the ignition for longer than 5 seconds (for vehicles with a starter
button, switch off the engine and open the driver's door).
›
End the connection in the SmartGate application.
›
Switch off Wi-Fi in the connected external device.
Automatic connection
If the external device once had a connection with SmartGate, then the connec-
tion is automatically restored after the ignition is started.
SmartGate web interface
SmartGate parameters can be set in the SmartGate web interface.
The following address must be entered in the web browser of the external de-
vice that is connected with SmartGate.
HTTP://192.168.123.1
The setting changes are only effective after pressing the buttons "Save" →
"Reboot".
Password/PIN code
The password for the Wi-Fi connection preset by the factory is the complete
vehicle identification number (entered in upper case); the PIN code for the Wi-
Fi direct connection is the last 6 digits of the vehicle identification number.
1)
The last 6 characters of the VIN vehicle identification number of your vehicle are displayed at position ....
2)
If the "Reboot" interface is not displayed, you must manually restore the web browser display.
50
Using the system
includes the last six digits
1)
» page 50.
After changing the password/PIN, the connection to SmartGate must be re-es-
tablished on the external device to be connected using the new password or
new PIN code.
Changing the password for the Wi-Fi connection
›
Open the SmartGate web interface
›
In the"WPA / WPA2 key:" menu item, enter the new password (8 to 63 alpha-
numeric characters and special characters, small and capital letters).
›
Confirm the password change by tapping on the "Save" interface.
›
Restart SmartGate by tapping on the "Reboot"
Changing the PIN code for the Wi-Fi Direct connection
›
Open the SmartGate web interface
›
In the "WiFi Direct PIN:"menu item, enter the new PIN code (6 digits).
›
Confirm the PIN code change by tapping on the "Save" interface.
›
Restart SmartGate by tapping on the "Reboot"
Note
If you have forgotten your password for the connection to SmartGate,
SmartGate must be reset to factory settings in a specialised workshop.
» page 50.
interface.
2)
» page 50.
interface.
2)