Table of Contents
Advertisement
9. Technical Specifications
Unless otherwise specified, the technical specifications applied are for TDS series
only, and Probes attenuation set as 10X. Only if the oscilloscope fulfills the following
two conditions at first, these specification standards can be reached.
This instrument should run for at least 30 minutes continuously under the
specified operating temperature.
If change of the operating temperature is up to or exceeds 5℃, do a
"Self-calibration" procedure (see "How to Implement Self-calibration" on P14).
All specification standards can be fulfilled, except one(s) marked with the word
"Typical".
Performance Characteristics
Bandwidth
Channel
Acquisition
Input
9.Technical Specifications
Mode
Waveform Capture
rate
Max Sample rate
(real time)
Input coupling
Input impedance
Probe
attenuation
factor
Max. input voltage
Bandwidth limit
Channel
–channel
isolation
Instruction
TDS7104
TDS8104
TDS8204
Normal, Peak detect, Averaging
50,000
Four CH
TDS7104
Dual CH
Single CH
Four CH
TDS8104
Dual CH
TDS8204
Single CH
DC, AC , Ground
1MΩ±2%, in parallel with 10pF±5pF
50Ω±1%
1X, 10X, 100X, 1000X
1MΩ input impedance:
400V (PK-PK) (DC + AC PK-PK)
50Ωinput impedance:
5V (PK-PK) (DC + AC PK-PK)
20MHz, full bandwidth
50Hz: 100 : 1
10MHz: 40 : 1
73
100MHz
200MHz
4
500MS/s
1GS/s*
1GS/s
1GS/s
2GS/s*
2GS/s
Advertisement
Table of Contents
