Slope Trigger - Owon tds series User Manual

The description of the Pulse Width Trigger Menu is as follows:
MENU SETTING
Trigger
Mode
Source
Coupling
When
Mode
Holdoff

4. Slope Trigger

Slope trigger sets the oscilloscope as the positive/negative slope trigger within the
specified time.
The description of the Slope Trigger Menu is as follows:
MENU SETTING
Trigger
Slope
Mode
①
②
Source
③
④
slope
When
5.Advanced User Guidebook
INSTRUCTION
Pulse Set vertical channel trigger type as pulse trigger.
①
Channel 1 as trigger signal.
②
Channel 2 as trigger signal.
③
Channel 3 as trigger signal.
④
Channel 4 as trigger signal.
AC Not allow DC portion to pass.
DC Allow all portion pass.
HF Not allow high frequency of signal pass and only low
frequency portion pass.
LF Not allow low frequency of signal pass and only high
frequency portion pass
Polarity
Choose the polarity
Select pulse width condition and adjust the G knob to
set time.
Auto Acquire waveform even no trigger occurred
Normal Acquire waveform when trigger occurred
Single When trigger occurs, acquire one waveform then stop
Holdoff 100ns~10s, adjust G knob to set time interval before
another trigger occur.
Reset Set Holdoff time as 100ns
INSTRUCTION
Set vertical channel trigger type as slope trigger.
Channel 1 as trigger signal.
Channel 2 as trigger signal.
Channel 3 as trigger signal.
Channel 4 as trigger signal.
Slope selecting
Set slope condition; turn the G knob to set slope time.
34