Yamaha VS-10 Owner's Manual page 10

INSTALLATION
Installing the Control Center Vertically
Apply the two supplied side pads to the side of the control center and attach to the supplied supporting stand.
1
Peel off the seals of the side pads and apply to the two indented parts (near to the front panel) on the
left side of the control center.
Peel off the seal.
Side pad
2
Attach the control center with the pads applied side facing down to the supporting stand as shown in
the illustration below.
Front panel
Note
• Using only the supporting stand makes the control center unstable and the front door cannot open. Be sure to use the side pads as well.
CAUTIONS
• Be sure to place the control center with the left side down.
• When installing the control center vertically on a high place such as on a shelf, do not place close to the edge.
8
Apply to the indented part.
Bottom panel
Apply to the indented part.
Lift in this direction.
Front panel
Rear panel
A supporting stand