Adjusting The Speaker Output Levels; Test - Yamaha VS-10 Owner's Manual

ADJUSTING THE SPEAKER OUTPUT LEVELS

When reproducing the source encoded with a Dolby Digital, Dolby Surround or DTS, it is important to adjust the sound
output level heard at the listening position to the same from each speaker. Therefore, the best performance of these digital
sound fields can be obtained. Even when the other sound field is selected, you can enjoy the characteristics of each sound
field.
Speaker output levels may be adjusted using the remote control before playback by following the steps.
ON/OFF
1
EFFECT
VS10 TV
–
VOL
MEMORY
1
4
7
MENU
–
- --
/
SUBWOOFER
2 –
NIGHT MODE
1
Press p to turn on the power.
If the STANDBY indicator is lit, turn on the power
using p on the remote control. If the main power is
off (when the STANDBY indicator is not lit), turn on
the power by pressing POWER on the control center.
CAUTION
When the NX-SW10 (sold separately) is connected to the
control center, insert the plug of the AC power supply
cord of the subwoofer SW-VS10 into an AC outlet
beforehand and turn on the power of the control center.
VCR SAT
P
+
VOL
P
SET
DSP INPUT
2 3
5 6
8 9
+
0
C/P
SUBWOOFER
+

TEST

2
Press TEST.
A test tone (like pink noise) will be output in the
following order.
When only the VS-10 is connected or the
VIRTUAL SURROUND is selected:
Main
speaker
LEFT
LEFT
SURROUND
(Virtual)
When the NX-SW10 is connected:
Main
speaker
LEFT CENTER
LEFT
SURROUND
Rear speakers
Main
speaker
RIGHT
RIGHT
SURROUND
(Virtual)
Main
speaker
RIGHT
RIGHT
SURROUND
15