Performance Profi Le - SKC QuickTake 30 Operating Instructions Manual

Performance Profi le
Flow Range:
Flow Compensation
Accuracy:
Compensating Flow
Back Pressure Range:
Typical Back Pressure of Sampling Media (inches water)
Flow Rate (L/min)
Filter/Pore Size (μm)
25-mm MCE, 0.8
25-mm MCE, 0.45
37-mm MCE, 0.8
37-mm PVC, 5.0
Compare the information in this table to pump compensation range to determine appropriate applications.
Power:
Battery Recharge Time: Approximately 5 hrs
(varies with batt ery capacity
and level of discharge)
Typical Cumulative
Run Time:
†
Temperature:
Operating Humidity:
10 to 30 L/min
± 5% of set fl ow
10 L/min at 90 inches water back pressure
20 L/min at 50 inches water back pressure
30 L/min at 15 inches water back pressure
10 12
65 80
138 172
22 28
9 11
• Rechargeable lithium-ion (Li-Ion) battery, 7.4 V, 9.6-Ah
capacity, 71.04 Wh
• Battery with AC charger/adapter, 100-240 V
Spore Trap* (e.g., VersaTrap): 5 hrs at 15 L/min (battery only)
BioStage viable cascade impactor: 4 hrs at 28.3 L/min (battery only)
25-mm, 1.2-μm MCE fi lter: 9+ hrs at 10 L/min
37-mm, 0.8-μm MCE fi lter: > 14 hrs at 10 L/min (battery only)
* Sampling times when using spore traps are usually ≤ 10 min. SKC
recommends reducing length of sample time when using a 30 L/min
fl ow rate to prevent overloading the media.
† Results obtained using a new pump and new fully charged batt eries. Pump and
batt ery performance may vary.
The AC charger/adapter can be used to extend batt ery run
time, but it is not a batt ery eliminator. Therefore, it will
not provide indefi nite run times.
Operating: 32 to 113 F (0 to 45 C)
Storage: -4 to 95 F (-20 to 35 C)
Charging: 32 to 113 F (0 to 45 C)
0 to 95% non-condensing
Protect sample pump from weather when in use outdoors.
15 20
103 148
> 200 —
36 51
15 21
To achieve, use QuickTake 30 with a fully
charged battery and AC charger/adapter.
4