SKC QuickTake 30 Operating Instructions Manual page 21

Setting the Number of Cycles (n)
1. Press  or  to increase or decrease the number of
cycles. The display will fl ash. If no change to the number
of cycles is desired, press
2. When fi nished, press
To save the new sett ing: Press [
to Intt .
To ignore the new sett ing: Press
Start sampling by pressing [
to 59 seconds, then switch to minutes up to the set minutes
run time. The pump will stop for the programmed number
of delay minutes while the LED displays a count down from
the set delay time to zero. The pump will start sampling
again. The pump will beep four times and the display will
fl ash donE after the desired cycles are completed. Press
to display cumulative run time. Press

Press [ ] to return the display to the run time preset. If a
repeat sample is desired, press [
Intermitt ent sampling sett ings are retained when the pump goes to sleep.
User Options During Intermittent Sampling
Viewing number of cycles remaining and cumulative run
time

Press repeatedly while the sample or delay is running.
If the unit is left untouched for fi ve seconds, the display
will automatically return to cumulative time.
Terminating a sample and resett ing the pump
There is no Hold available in intermitt ent sampling.
Therefore, pressing [
LED will display SErr (sampling error). Press
cumulative run time. Press [
presets.

to return to Intt .

. Stor will fl ash on the display.

]. Press

. The LED will return to Intt .

]. The LED will count up


].

] will stop the sampling and the

] to return to run time
20

to return

to return to donE.

to view
Digital display:
Set number of cycles
Digital display:
Sample run completed