Quick Guide - SKC QuickTake 30 Operating Instructions Manual

QuickTake 30 Quick Guide
Terms »
Star Button 
Turns on LED, toggles between displays, and exits without saving
Up and Down Arrow Buttons 
Scroll through presets, increase or decrease sampling parameters, and toggle
between setup options
Button Sequence
 or  = Press individually
[] = Press both simultaneously
 = Security code, press in sequence
Programming Sequences »
• To activate pump LED:
Press and hold  for 2 seconds.
• To check battery status:
Press .
• To choose a run time preset:
Press  or  to scroll through presets. Once desired preset displays, press
[] to start sampling.
• To Run or Hold:
Press [].
• To repeat a sample run:
From Done, reset (rSEt), or sampling error (SErr), press [] to return to run
time preset. Press [] to sample.
• To change or calibrate fl ow:
Note: Flow rate does not appear on LED.
Press  or  and scroll to a run time preset. Press and hold CAL for 2 seconds.
(Does not require a security code.) Press  or  to change fl ow rate until desired
fl ow appears on calibrator. Press . When Stor displays, press [] to save
setting or  to ignore changes to fl ow setting.
• To interrupt run, terminate a sample, or reset pump:
While in Hold, press . Sample reset (rSEt) will display. Press [] to reset
pump or  to ignore reset and return to Hold.
www.skcinc.com
SKC Inc., 863 Valley View Road, Eighty Four, PA 15330
1