Table of Contents
Advertisement
How to connect your extended power cables
❋ ❋ Items to prepare (compressor and insulation tape should be prepared by an installation technician.)
Tools
Crimping plier
Spec
Shape
1. As shown in the figure, peel off the shields from the rubber/wire of the
power cable.
- Peel off 20 mm of the wire shields of the tube installed already.
2. Insert both sides of core wire of the power cable into the connection sleeve.
f Method 1
f
- Push the core wire in to the sleeve from both sides.
• After peeling off the tube wire, you must insert a contraction tube.
CAUTION
f Method 2
f
- Twist the wire cores together and push it in to the sleeve.
3. Using a cramping pliers, compress the two points and flip it over and
compress another two points in the same location.
- The compression dimension should be 8.0.
- After compressing it, pull both sides of the wire to make sure it is firmly
pressed.
f Method 1
f
Compress it 4 times
5mm
4. Wrap it with the insulation tape twice and position your contraction tube in the middle of the insulation tape.
f Method 1
f
Insulation tape
40mm
Mirage_AP36M0@_IBIM_E_34573A(1).indd 53
Connection sleeve (mm)
MH-14
20 x ø 6.5(HxOD)
f Method 2
f
Compress it 4 times
5mm
f Method 2
f
Insulation tape
35mm
Insulation tape
Contraction tube (mm)
Width 19mm
70 x ø 8.0(LxOD)
Power cable (provided)
20
20
120
Wire tube power cable
20
f Method 1
f
Sleeve
f Method 2
f
Sleeve
Comp. dim.
(Unit: mm)
20
60
53
2012-02-21 오후 1:10:02
Advertisement
Table of Contents
