5
To set the "Stabilizer" function
If the image is incorrect, even after the gradation levels have been adjusted, set the
"Stabilizer" function.
The following two modes are available with the "Stabilizer" function.
G
Reset And Stabilizer Mode
G
Stabilizer Mode
The "Stabilizer" function performs an image stabilization based on past data up to
the previous session.
Image stabilization should normally be performed with "Stabilizer Mode" selected.
Select "Reset And Stabilizer Mode" only if the desired effect cannot be attained with
the "Stabilizer Mode".
1
Press the [UTILITY] key.
2
Touch [Admin. Mode].
3
Using the keypad, enter the administrator access code.
4
Touch [Expert Mode].
5
Touch [Stabilizer].
6
Press the [START] key.
The indicator on the
[START] key changes
to orange, and the
image stabilization
operation is performed.
The indicator on the
[START] key changes
back to green.
The image stabilization
procedure is finished.
5-58
5.5 Administrator Mode Operations
Konica 8020/8031