Phone User Interface; Web User Interface - Yealink SIP-T2XP Administrator's Manual

Administrator's Guide for SIP-T2xP and SIP-T19P IP Phones
2. The message "Initializing, Please Wait" appears on the LCD screen when the IP
phone starts up.
3. The main LCD screen displays the following:
Time and date

Soft key labels (not applicable to SIP-T20P IP phones)

4. Press the OK key to check the IP phone status, the LCD screen displays the valid IP
address, MAC address, firmware version, etc.
If the IP phone has successfully passed through these steps, it starts up properly and is
ready for use.
You can use the following methods to set up and configure IP phones:

Phone User Interface



Web User Interface


Configuration Files

The following sections describe how to configure IP phones using each method above.
An administrator or a user can configure and use IP phones via phone user interface.
Access to specific features is restricted to the administrator. The default password is
"admin"(case-sensitive). Not all features are available on phone user interface.
An administrator or a user can configure IP phones via web user interface. The default
user name and password for the administrator to log into the web user interface are
both "admin" (case-sensitive). Almost all features are available on web user interface.
IP phones support both HTTP and HTTPS protocols for accessing the web user interface.
For more information, refer to
You can deploy IP phones using configuration files. There are two configuration files
both of which are CFG formatted. We call them Common CFG file and MAC-Oriented
CFG file. A Common CFG file will be effectual for all IP phones of the same model.
However, a MAC-Oriented CFG file will only be effectual for a specific IP phone. The
Common CFG file has a fixed name for each IP phone model, while the MAC-Oriented
18
Web Server Type on page 117.