Yealink SIP-T2XP Administrator's Manual page 42
Hide thumbs
Also See for SIP-T2XP:
- Administrator's manual (589 pages) ,
- Auto provisioning manual (294 pages) ,
- Provisioning manual (294 pages)
Table of Contents
Advertisement
Administrator's Guide for SIP-T2xP and SIP-T19P IP Phones
To configure a static IPv4 address via web user interface:
1.
Click on Network->Basic.
2.
In the IPv4 Config block, mark the Static IP Address radio box.
3.
Enter the desired values in the IP Address, Subnet Mask, Gateway, Primary DNS
and Secondary DNS fields.
4.
Click Confirm to accept the change.
A dialog box pops up to prompt that settings will take effect after a reboot.
5.
Click OK to reboot the IP phone.
To configure the IP address mode via phone user interface:
1.
Press Menu->Settings->Advanced Settings (password: admin) ->Network->WAN
Port.
2.
Press
3.
Press the Save soft key to accept the change.
The IP phone reboots automatically to make settings effective after a period of time.
To configure a static IPv4 address via phone user interface:
1.
Press Menu->Settings->Advanced Settings (password: admin) ->Network->WAN
Port->IPv4->Static IP Client.
2.
Enter the desired values in the IPv4, Subnet Mask, Default Gateway, Pri DNS and
Sec DNS fields.
3.
Press the Save soft key to accept the change.
The IP phone reboots automatically to make settings effective after a period of time.
Note
Using the wrong network parameters may result in inaccessibility of your phone and may
also have an impact on your network performance. For more information on these
parameters, contact your network administrator.
26
or
to select IPv4, IPv6 or IPv4&IPv6 from the IP Mode field.
Advertisement
Table of Contents
