General Problems - Xerox 6204 User Manual

General Problems

If you think that there is a problem with the machine, check the machine status again.
WARNING:
supply. To avoid the risk of electric shock, never open or remove covers that are secured with
screws, unless you are specifically instructed to do so in the User Guide. Always follow the
instructions in the User Guide to retain your install/reinstall options. Never attempt to alter the
machine or change its parts because doing so may result in fire or smoke.
Symptoms
Power is not
switched On.
Touch screen is
dark.
A message is
displayed.
Downloaded From ManualsPrinter.com Manuals
This machine contains precision measuring equipment and uses a high-voltage power
Check
Is the circuit breaker (main
power switch) or the power
switch of the machine off?
Is the power cord plugged
into the power outlet?
Is the power cord
disconnected from the
machine?
Is power of the correct
voltage being supplied?
Is the <Power Saver> button
illuminated?
Is the brightness dial set too
low?
Did a paper jam occur?
Is the message "Initializing"
displayed?
Remedy
Turn on the circuit breaker and then the power switch.
Refer to the section on Powering the System On/Off.
Turn off the circuit breaker and power switch, and firmly
plug in the power cord. Then turn on the circuit breaker
(main power switch) and power switch.
Refer to the section on Powering the System On/Off.
The machine must be connected to a 120V (volts), 15A
(amperes) supply in the U.S., and to a 220-240V supply in
Europe.
Refer to the section on Power Connection.
The machine is in the Power Saver mode. Press the
<Power Saver> button on the control panel to cancel the
Power Saver mode.
Refer to the section on Exiting the Power Saver Mode.
Use the brightness dial to adjust display brightness.
Refer to section on the Control Panel.
Refer to the section on Paper Jams.
If the message is displayed for more than 3 minutes,
contact your Xerox Customer Support Center.
Xerox 6204 Wide Format Solution
Problem Solving
7-3
User Guide