Replacing The Cover; Adjusting The Hp Netserver Feet - HP netserver e 800 Service Manual

Chapter 1

Replacing the Cover

To replace the cover, follow these steps:
1. If you have been installing accessories or servicing the NetServer, return the feet to the normal
position, before turning the NetServer upright. Refer to "Adjusting the NetServer Feet."
2. If necessary, return the air duct to its closed position.
3. Place a hand on each side of the cover at the bottom edge and press inward while lowering the
cover onto the chassis. The cover has flanges that rest on the rails inside the chassis.
Bottom of
Chassis
4. Push the cover forward until it is seated within the slot at the front of the chassis.
5. Replace the six T-15/slotted thumbscrews in the rear.
6. Re-lock the cover with the key lock at the rear of the NetServer.

Adjusting the HP NetServer Feet

The stabilizing feet are used to steady the HP NetServer during normal operation and must be turned
outward. When adding internal accessories to the NetServer, turn the feet inward so that the NetServer will
lie flat on its side.
Replacing the Cover
Turn Feet Inward before Laying the NetServer on Its Side
Front of
Chassis
General Information
3