Top Cover; Removing The Top Cover; Figure 6-3 Removing And Replacing The Top Cover - HP Integrity rx4640 Upgrade Manual

Hide thumbs Also See for Integrity rx4640:

Table of Contents

Removing and Replacing Core I/O Cards

Top Cover

To remove the top cover, perform the following steps:

Step 1. If rack mounted, slide the HP Server out from the rack until it stops. See "Accessing a Rack

Mounted Server" on page 77.

Step 2. Loosen the two captive thumbscrews that hold the top cover in place.

Step 3. Pull the cover toward the rear of the server to free the tabs from the slots in the center of the

chassis and lift it straight up.

Figure 6-3

Removing and Replacing the Top Cover

Thumbscrews

Chapter 6

Table of Contents