Hard Disk Drive (Cage Mounted); Removing A Hard Disk Drive (Cage Mounted) - HP netserver e 800 Service Manual

Chapter 6

Hard Disk Drive (Cage Mounted)

Removing a Hard Disk Drive (Cage Mounted)

The replacement of the mass storage cage mounted drives is the same for IDE or SCSI drives. The IDE
drives require the setting of jumpers on the drives for the master and slave configuration before installing the
drives. The SCSI drives are set up during the operation of the SCSI configuration utility.
CAUTION
1. If the NetServer is operating, power down the NetServer.
2. Disconnect the power cord and any external cables connected to the NetServer. If necessary,
label each one to expedite re-assembly.
3. Remove the cover and turn in the NetServer feet (so that the NetServer will lie flat on its side).
4. Lay the NetServer on its side (components showing).
5. Unsnap the air duct and move it out of the way.
Replacing a Hard Disk Drive (DAT shown)
Install and remove connectors carefully, and avoid displacing any pins.
Replacing Parts
71