Power Supply; Removing Power Supply - HP netserver e 800 Service Manual

Chapter 6

Power Supply

Removing Power Supply

The low voltage ON/OFF switch on the front panel controls the power supply.
To replace the power supply:
1. If the NetServer is operating, power down the NetServer.
2. Disconnect the power cord and any external cables connected to the NetServer. If necessary,
label each one to expedite re-assembly.
3. Remove the cover.
4. Remove the four screws securing the power supply to the chassis. Three are located at the rear
of the chassis and the fourth is located on the right side.
5. Disconnect the four power cables from the chassis connectors and the FDD.
6. Remove the power supply.
78
Replacing the Chassis Fan
Replacing Parts