Removing And Replacing The System Cover; Removing And Replacing The Cover; Tools Required; Removing The Cover - HP NetServer E 60 Installation Manual

3 Removing and Replacing the
System Cover

Removing and Replacing the Cover

WARNING
Before removing the cover, always disconnect the power cord
and unplug telephone cables. Disconnect the power cord to
avoid exposure to high energy levels that may cause burns
when parts are short-circuited by metal objects such as tools
or jewelry. Disconnect telephone cables to avoid exposure to
shock hazard from telephone ringing voltages.

Tools Required

To remove and replace the cover, you will need a Torx
blade screw driver.

Removing the Cover

To remove the cover, follow these steps:
NOTE
These steps do not include the removal of the front bezel of the
system. You do not need to remove the front bezel of the
HP NetServer E 60 to install internal accessories, such as
memory or mass storage.
1. Turn off the NetServer and disconnect the power cord and any phone line.
2. Unlock the cover: use the key in the key bag located on the rear of the
NetServer. The locking mechanism is at the rear (see Figure 3-1).
3. Remove six (6) Torx 15/slotted screws (see Figure 3-1 ).
®
15 driver or ¼-inch flat
15