Flexible Disk Drive; Removing The Flexible Disk Drive - HP netserver e 800 Service Manual

Chapter 6

Flexible Disk Drive

Removing the Flexible Disk Drive

1. If the NetServer is operating, power down the NetServer.
2. Disconnect the power cord and any external cables connected to the NetServer. If necessary,
label each one to expedite re-assembly.
3. Undo the six thumbscrews securing the cover to the chassis.
4. Remove the cover.
5. Remove the bezel.
6. At the rear of the flexible disk drive, carefully disconnect the power and data cables.
7. Remove the two screws securing the flexible disk drive to the chassis.
Replacing the Bezel
Replacing Parts
65