HP netserver e 800 Service Manual page 41

Chapter 4
Code Description
0108
Mouse and Keyboard
connections reversed
0200 Serial Port Controller
resource conflict
0201 Parallel Port Controller
resource conflict
0300
Flexible disk drive (A) boot
error
Problem/Solution
automatically validate the change.
2. Otherwise, verify the mouse connector is firmly
connected.
3. If the problem persists, your mouse may need to be
replaced. Contact your service representative.
POST has detected the mouse and keyboard connections
are reversed.
To correct this:
1. Turn the NetServer off.
2. Swap the mouse and keyboard connections.
3. Turn on the NetServer power and reboot the
NetServer.
POST has detected an address space or IRQ resource
conflict between one of the integrated serial port controllers
and an accessory board.
To correct this:
1. If an integrated serial port is not needed, run the
Setup Utility and disable the related serial port.
2. If the integrated serial port is needed and its settings
cannot be modified, the accessory board's IRQ and
address space must be reconfigured to use other
free resources. Refer to the accessory board
installation manual for information.
POST has detected an address space or IRQ resource
conflict between the integrated parallel port controller and an
accessory board.
To correct this:
1. If the integrated parallel port is not needed, run the
Setup Utility and disable the parallel port.
2. If the integrated parallel port is needed and its
settings cannot be modified, the accessory board's
IRQ and address space must be reconfigured to use
other free resources. Refer to the accessory board
installation manual for information.
POST has detected the flexible disk drive (A) reported an
error during its self-test.
To correct this:
1. Verify a diskette can be properly inserted and
Diagnostics
35