Name Type; Tenkey Mod; Tenkey No - FOR-A MFR-1616 Operation Manual

5-3-3-8. NAME TYPE

This menu allows you to select a name display type for the destination, source and level.
SETTING>NAME TYPE
DST BTN :PHY NUM <ENT>
Turn the control knob to select a button group from the destination, source and level
buttons. Press the control knob to confirm the selection.
SETTING>NAME TYPE
DST BTN :PHY NUM <ENT>
Turn the control knob to select a display type, and press the knob to confirm.
Display type
PHY NUM Physical number display
ASCII 1-byte character code
(Alphanumeric characters and
symbols)
KANJI 2-byte character code including
1-byte character code
(Not selectable for LEVEL)
* Up to three 2-byte characters can be displayed. Mix use with 1-byte characters is
supported.
* Total of one 2-byte character and four 1-byte characters can be displayed in mixed
use.

5-3-3-9. TENKEY MOD

This menu allows you to change the method to confirm changes in numeric keypad mode.
SETTING>TENKEY MOD
INPUT MODE:ENTER <ENT>
Turn the control knob to select a method from the below options, and press the knob to
confirm.
ENTER : Enter a value and press the ENTER button on the displayed numeric keypad on
the remote control panel.
DIRECT: Enter a value using the numeric keypad. The value is confirmed.

5-3-3-10. TENKEY NO

This menu allows you to select the threshold of the setting range for each setting category
in numeric keypad mode.
SETTING>TENKEY NO
INPUT START NO:0<ENT>
Turn the control knob to select 0 or 1, and press the knob to confirm.
Description
51
Example indication
DST SRC LEVEL