Simultaneous Crosspoint Switching; Main Unit Stored Salvo; Remote Control Panel Button Assigned Salvo - FOR-A MFR-1616 Operation Manual

6-2. Simultaneous Crosspoint Switching

The simultaneous crosspoint switching function allows you to simultaneously switch multiple
crosspoints by the press of one button. There are two ways to do so. One is the Salvo function
which performs the switching by recalling the pre-assigned crosspoints. The other is the Take
function which allows you to assign and switch multiple crosspoints simultaneously.
 The pre-assigned crosspoints for a SALVO can be saved to either the routing switcher main
unit or a button on the remote control panel.

6-2-1. Main Unit Stored Salvo

This type of salvo allows you to store crosspoint data to be simultaneously switched. The
stored data can be recalled from any connected remote control panel.
 Storing Salvo data
Salvo data can be stored in the Web-based Control.
 See [Web-based Control: Salvo page].
 Executing Salvos
Use a SALVO (MU RECALL) button on the remote control panel as shown in the procedure
below.
(1) Assign a SALVO button on the remote control panel. Set the salvo for MU RECALL, and
select a Salvo number.
 See section 5-3-3-12 "BTN ASSIGN" and 5-4-2. "Button Assignment Change."
(2) Pressing the SALVO button to executes the salvo. The crosspoints stored to the salvo
number are simultaneously set.

6-2-2. Remote Control Panel Button Assigned Salvo

This type of salvo allows to you assign crosspoints to be simultaneously switched to a button.
The salvo can be recalled only by the SALVO button of the remote control panel.
Remote Control Stored Salvo data can also be stored using the Web-based Control.
 See [Web-based Control: Salvo page]
 Storing Salvo Data to the Remote Control Unit
Use a SALVO (RU STORE) button on the remote control panel as shown in the procedure
below.
(1) Assign a SALVO button on the remote control panel. Set the salvo for RU STORE.
 See section 5-3-3-12 "BTN ASSIGN."
(2) Store salvo data as shown in the table below.
Step
Press the SALVO button as shown below.
The button is highlighted and ready for
1
crosspoints to be assigned.
To assign crosspoints to a salvo, press
a destination button then a source button.
The selected buttons flash.
2
Repeat the procedure for all crosspoints.
Description
73