Chop Function; Crosspoint Switching Using Take Function - FOR-A MFR-1616 Operation Manual

6-1-3. CHOP Function

The CHOP function allows you to alternate 2 images to compare the images.
 Enabling the CHOP function
(1) Press one of 2 source buttons (source A) to compare.
(2) While holding down the source button, press and release another source button (source
B).
Images of source A and B alternate.
Source A
Press source button A.
→ Source A is output.
ソース A ボ

6-1-4. Crosspoint Switching Using TAKE Function

タンを押す
⇒ ソース A
Crosspoint switching using the Take function is available by the remote control panel that is
が出力
assigned Take.
The Take function enables crosspoint switching by the TAKE button.
The Take function has 2 modes that can be assigned to different remote control panel
respectively. To select the Take mode, select Preset or Direct under Take Mode in in the
[Web-based Control: RU Settings page].
 Preset mode
Press the TAKE button to enable Take, and select crosspoints, then press the TAKE button
to switch crosspoints.
 Direct mode
The Take function is always enabled. Select crosspoints, then press the TAKE button to
switch crosspoints.
 Ex.1: To use the TAKE button assigned to Preset mode
Step
Press the TAKE button.
The take function will be enabled,
1
and the button will be highlighted.
Select a crosspoint by selecting a destination
button and source button.
The selected buttons will blink.
2
* To switch multiple crosspoints, repeat the procedure.
After completing the crosspoint selection, press the blinking TAKE button to
switch the crosspoint/s.
3
In multiple crosspoint switching, the last set of destination and source buttons will
be highlighted.
Once a crosspoint switch has been completed, the TAKE button preset mode will be
disabled. The button will return to direct mode.
To switch crosspoints in the preset mode again, repeat the procedure from step 1.
Source B
Holding down source button A,
press source button B.
→ Source B is output.
ソース A ボ
タンを押し
たまま
ソース B ボ
タンを押す
⇒ ソース B
が出力
Description
71
Source A
Release source button
B.
→ Source A is output.
ソース B ボ
タンを離す
⇒ ソース A
が出力