Simultaneous Switching By The Take Function; Simultaneous Switching By The Link Function - FOR-A MFR-1616 Operation Manual

After completing the crosspoints assignments, press the SALVO button again.
The menu display appears as shown below.
3
To add crosspoints to an existing salvo, select a salvo number by turning the control
4 knob. Salvo numbers to which no crosspoints are assigned are indicated with (NEW).
Turn the control knob to select a number, and press the knob to confirm the selection.
 Executing Salvos
Use a SALVO (RU RECALL) button on the remote control panel as shown in the procedure
below.
(1) Assign a SALVO button on the remote control panel. Set the salvo for RU RECALL, and
select a Salvo number.
 See section 5-3-3-12 "BTN ASSIGN" and 5-4-2. "Button Assignment Change."
(2) Pressing the SALVO button to executes the salvo. The crosspoints stored to the salvo
number are simultaneously set.

6-2-3. Simultaneous Switching by the Take Function

The TAKE button on the remote control panel allows you to simultaneously switch preset
crosspoints.
 See section 5-3-3-12 "BTN ASSIGN" for details on assigning the TAKE button.
 Executing the TAKE function
Refer to Ex. 1) and Ex. 2) in section 6-1-4. "Crosspoint Switching Using TAKE Function."

6-2-4. Simultaneous Switching by the Link Function

The LINK button on the remote control panel allows you to simultaneously switch crosspoints
associated with a specific crosspoint.
Pressing the LINK button enables or disables the Link function. The LINK button is
highlighted with a bright background when the function is enabled.
 See section 5-3-3-12 "BTN ASSIGN" for details on assigning the LINK button.
If the Link function is turned on, selecting a trigger crosspoint switches the slave crosspoints
with it. The trigger and slave crosspoints can be assigned using Web-based Control. Refer to
 See [Web-based Control: Link Settings page] for more details.
SALVO STORE
NO: 1 (NEW) <ENT>
74