Reset Modes - Extron electronics CCI Pro 700 User Manual

Reset Modes

The recessed
interface according to the table below. If necessary remove the interface from the base (see
Rear Panel Access
release the button.
Mode Purpose/Notes
Use this mode to revert
to the factory default
version if incompatibility
issues arise with
user-loaded firmware.
Use this mode to reset
all IP settings back to
factory defaults.
Use this mode to
restart with default
configuration.
CCI Pro 700 TouchLink Pro Conference Room Control Interface • Reference Information
button (see figure 5
Reset
on page 5). Use an Extron Tweeker or small screwdriver to press and
Reset Mode Summary
Activation
Hold in the recessed
Reset
for 30 seconds while applying
power to the interface.
NOTE: After a factory firmware
reset, update the device with
the latest firmware version. DO
NOT operate with the firmware
version that results from this
mode reset. This temporarily
resets the device to factory
default until power is recycled.
To use factory default firmware,
upload that version again.
Hold down the Reset button until
the Reset LED blinks two times
(over approximately 6 seconds).
Then, press Reset momentarily
(<1 second).
Hold down the Reset button until
the Power LED blinks 3 times (over
approximately 9 seconds). Then,
press Reset momentarily
(<1 second).
on page 6) on the rear panel resets the
, C
button The device reverts to the factory default
firmware.
Firmware reverts to the factory default
•
for a single power cycle.
• All user files and settings (drivers,
audio and video adjustments, IP
settings, and so on) are maintained.
NOTE: If you do not want to update
the firmware or perform this reset by
mistake, cycle power to the device
to return to the firmware version
running prior to the reset.
IP settings revert to factory defaults.
• DHCP turns off.
• IP address is set to 192.168.254.251.
• Subnet mask is set to 255.255.255.0.
• Gateway address is set to 0.0.0.0.
All other IP settings (for example,
•
domain and hostname) are set to
factory default values.
• Reset LED blinks three times in quick
succession during reset.
The device reverts to the factory defaults
except for firmware.
• IP settings reset as detailed above.
• All user configurations reset to default
values including IP settings and
real-time adjustments.
All user-loaded files are deleted.
•
• The Reset LED blinks four times in
quick succession during the reset.
Result
24