Network Submenu - Extron electronics CCI Pro 700 User Manual

Network Submenu

This submenu contains options to configure network settings. Network settings can be
assigned automatically with Dynamic Host Configuration Protocol (DHCP) or manually by
specifying an IP address, subnet mask, gateway address, and Domain Name Server (DNS)
IP address obtained from the network administrator. To finalize pending changes, press the
button directly below
Context
directly below
Figure 11.
• DHCP mode — Press the ◄ or ►
default is disabled). When enabled, only the host name can be changed.
Hostname — If DHCP mode is enabled, press the
•
host name (63 character maximum). Use the ◄ and ►
the cursor position and the
NOTE: Use the
• IP address — Press the
►
Navigation
The range is 0.0.0.0 to 255.255.255.255 (the default is 192.168.254.251).
NOTE: Use the
• Subnet mask — Press the
◄ and ►
values. The range is 0.0.0.0 to 255.255.255.255 (the default is 255.255.255.0).
NOTE: Use the
Gateway address — Press the
•
Use the ◄ and ►
enter values. The range is 0.0.0.0 to 255.255.255.255 (the default is 0.0.0.0).
NOTE: Use the
CCI Pro 700 TouchLink Pro Conference Room Control Interface • Setup Menu
. To cancel pending changes, click the
Apply
.
Main
Network Submenu — Page 1
Navigation
to enter values.
Keypad
button to enter a dash (
# Keypad
]
Navigation
buttons to move the cursor position and the
button to enter a period (
* Keypad
]
Navigation
buttons to move the cursor position and the
Navigation
button to enter a period (
* Keypad
]
buttons to move the cursor position and the
Navigation
button to enter a period (
* Keypad
button to enable or disable DHCP (the
]
Navigation
Navigation
) character.
-
button to edit the IP address. Use the ◄ and
Keypad
) character.
.
button to edit the subnet mask. Use the
) character.
.
button to edit the gateway address.
Navigation
) character.
.
button
Context
button to edit the
buttons to move
to enter values.
to enter
Keypad
to
Keypad
12