Table of Contents
Advertisement
Installation Overview
This section contains basic installation procedures.
1.
2.
3.
4.
5.
6.
7.
8.
Before starting, download and install the latest versions of the following software:
Global Configurator Plus and Professional — For configuring button actions
•
and functions of the interface.
NOTES:
•
Global Configurator Plus and Professional operates in either Plus mode or
Professional mode.
•
Global Configurator Professional access requires Extron Control
Professional certification.
GUI Designer — For designing LCD screen layouts.
•
Obtain the following network information from your network administrator:
DHCP status (on or off) — If DHCP is off, obtain the following:
•
IP address
•
Subnet mask
•
Gateway
•
Mount and cable the units:
a.
Mount the unit on a flat surface (see
b.
Remove the CCI Pro 700 from the base to access the rear panel connector (see
Rear Panel Access
on page 5).
c.
Route an Ethernet cable through the opening in the base (see
page 9).
d.
Connect an Ethernet cable from the network to the interface (see
Buttons and Connector
NOTE: If necessary, use a power injector along the Ethernet cable run to apply
power.
e.
Attach the base to the rear panel of the interface.
Use the setup menu to initially set up the interface (see
Set up a configuration for the interface with Global Configurator Plus and Professional.
Set up a layout with GUI Designer.
Upload GUI Designer and Global Configurator files.
Verify the configuration.
CCI Pro 700 TouchLink Pro Conference Room Control Interface • Installation
Mounting
on page 22).
on page 6).
Setup Menu
Cable Routing
on
Rear Panel
on page 10).
3
Advertisement
Table of Contents
